- 您现在的位置：买卖IC网 > Sheet目录1213 > EHE004 (Mide Technology Corporation)BOARD ENERGY HARVESTING
POWER MEASUREMENTS
Piezoelectric material produces mechanical strain
under the influence of an externally applied electrical
field, and conversely produces electrical potential in
capacitance in Farads, V is the piezo’s open circuit
voltage, and Δ t is a reasonable time interval (~ 10
seconds), and solving for C:
1 C V 2
response to applied mechanical strain. Products such
as the Volture? piezo energy harvester are typically
used in a cantilevered-beam configuration, in which the
piezoelectric beam is clamped at one end and the other
Yielding:
P AVG
2
t
V
end allowed to oscillate freely in response to vibration
normal to the flat surface of the beam, converting
these vibrations to in-plane material strain. The beam
C
2 P AVG
2
t
dimensions and tip mass determine the resonant
frequency of the beam, which is tuned to match the
dominant vibrational frequency of its environment,
mechanically amplifying this typically small vibration.
Power Measurements
The power output capability of the Volture? products
was measured in the following manner. In the
cantilevered beam configuration above, the Volture was
mounted to a shaker capable of generating vibrations of
The figure below shows the voltage (operating voltage)
on the capacitor and instantaneous power into capacitor
vs. time for a representative vibration level and
frequency. The V25W product was used, demonstrating
that the power increases until it peaks when the
operating voltage is at about half its open circuit value.
After that, it decreases.
See Application Note: Load Isolation Example.
Typical Power & Voltage vs Time
varying frequency and amplitude. Tip masses (four for
each product) were added to alter the natural frequency
of the Volture? products. The vibration frequency being
generated by the shaker was then matched to the
frequency of the Volture? product to provide resonant
and therefore optimized energy harvesting. Four
different amplitudes were tested (0.25, 0.375, 0.5, and
1.00g) at each of these frequencies. The piezo’s output
was rectified and then placed across a purely capacitive
load. The capacitor value was chosen using the
following equation for average power, where C is the
REVISION N0. 002
P PEAK
0
REVISION DATE: 01-23-2013
Time (Seconds)
V OPEN CIRCUIT
V OPEN CIRCUIT
7
发布紧急采购，3分钟左右您将得到回复。
相关PDF资料
EHFW2BPKG
CONN EEE1394 FMALE T/H BLK 4-40
EHFWX2X
CONN FIREWIRE FEEDTHROUGH
EHHD15FF
CONN DSUB 15PIN FMAL-FMAL NICKEL
EHLC2M
CONN FIBER OPTIC LC/LC MULT MODE
EHSC2M
CONN FIBER OPTIC ST2 DUAL MODE
EHST2
CONN FIBER OPTIC ST2 SINGLE MODE
EHUSBABBX
CONN USB A FEMALE TO B FEMALE
EHUSBBABX
CONN EH USB B-A BLACK
相关代理商/技术参数
EHEA 1PR
制造商:Nexans 功能描述:CABLE SCRN 1CORE 7/0.2MM 100M 制造商:NEXANS 功能描述:CABLE, SCRN, 1CORE, 7/0.2MM, 100M 制造商:Nexans 功能描述:SHLD MULTICOND CABLE, 1COND, 24AWG, 328FT, 250V; Reel Length (Imperial):328ft; Reel Length (Metric):100m; No. of Conductors:1; Conductor Size AWG:24AWG; Voltage Rating:250V; No. of Strands x Strand Size:7 x 0.2mm; Cable Type:Shielded;RoHS Compliant: Yes
EHEA 2PR BLACK
制造商:Nexans 功能描述:
EHEALTH-GW-SDK
制造商:Bluegiga Technologies Inc 功能描述:EHEALTH SOFTWARE DEVELOPMENT KIT (SDK) LICENSE*
EHF-103-01-F-D
制造商:Samtec Inc 功能描述:.050 EJECTOR HEADER ASSEMBLY - Bulk
EHF-10301-F-D-RA
制造商:SAMTEC 制造商全称:Samtec, Inc 功能描述:.050 EJECTOR HEADER ASSEMBLY
EHF-10301-F-D-SM
制造商:SAMTEC 制造商全称:Samtec, Inc 功能描述:.050 EJECTOR HEADER ASSEMBLY
EHF-10301-FM-D-RA
制造商:SAMTEC 制造商全称:Samtec, Inc 功能描述:.050 EJECTOR HEADER ASSEMBLY
EHF-10301-FM-D-SM
制造商:SAMTEC 制造商全称:Samtec, Inc 功能描述:.050 EJECTOR HEADER ASSEMBLY